In-Band S&P for NAQP – Quick homebrew 1/4 wave vertical

1/21/2023 – This morning I quickly built a 1/4 wave vertical for 15 meters, and the ability to add a stinger for the antenna to function on 20 meters. The antenna is for the exclusive use of the S & P station C which is interlocked with run station B.

The vertical is cross polarized with the yagis on the main tower, so this helps reduce in-band interference.

KD7YS was the exclusive operator today for S&P, and in the first 7 hours of the contest, this antenna and setup added 12% to our total QSO count.

The antenna is 1/2″ EMT. The tilt base is a 2×4 stake driven in the ground, with 3-inch drywall screws serving as the pivot and to keep the pipe vertical. I had some scrap CAT5 cable. I burned 3 inches of the insulation off the ends, cleaned the bare wire in a vinegar and salt solution, then soldered 2 cables into 1 of 4 ring terminals, for a total of 8 random length radials laying on the ground.

Leave a Reply

Your email address will not be published. Required fields are marked *